Mean Well TN-3000 Manual de Instruções Página 11

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 20
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 10
9
Factory Setting
AC Charger
Transition Voltage
AC Charger
Start Up Voltage
Solar Charger
Start Up Voltage
112 212 124 224 148 248
14.3V
11V
13.3V
28.5V
22V
26.5V
57V
44V
53V
Solar Charger
Shut Down Voltage
Inverter
Shut Down
14.3V
10.5V
28.5V
21V
57V
42V
t5: When the capacity of batteries go down to about 75% (battery voltage around
t6: If the energy provided by the solar panels is lower than consumed by the loads,
t7: If the power consumption of the loads does not decrease and the AC main is
t8: When lacking AC main, the CPU will shut down the whole system if the capacity
26.5V), solar charger will restart and begin charging.
the users to take proper action.
"Solar Charger" charge the batteries to achieve the goal of energy-saving.
the CPU will provide LED indication to the user know why the inverter has shut
off.
The initial state of TN/TS-1500 is set to 120Vac/60Hz or 230Vac/50Hz, "UPS mode"
and disabled "Saving Mode" is activated. If the users need to revise it for certain
application, it can be done through the setting button on the front panel (Please
refer to section 5.3). The unit will start up automatically after the setting procedure
is finished and the new settings will be executed. These new settings will be kept
even if AC, battery, and solar is disconnected or occurrence of fault conditions
leading to failure of output voltage thus requiring powering the inverter OFF and
ON.
voltage of battery bank will decrease gradually to 20% of its capacity
(battery voltage around 22V), the built-in buzzer will be activated and inform
normal, CPU will detect this and the unit will be transferred to "Bypass Mode".
The utility will provide energy to the loads and charge the battery bank at the
same time in order to prevent the unit from shutting off. If the solar current is
higher than 3A, the CPU will not activate the "AC charger" and just let the
of external battery bank is less than 10% (battery voltage around 21V)
in order to prevent over-discharging and reducing its lifetime. After shut down,
5. Initial Setup of TN/TS-1500 (Operating Mode, Output Voltage, Frequency,
and Saving Mode)
TN/TS-1500
5.1 Initial State
5.2 Initial Set Point for Transition Voltages
Vista de página 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Comentários a estes Manuais

Sem comentários